Broadcast Keys; Front Ir Enabled; Wired Keypad Enabled; Display Error Messages - Christie Matrix StIM-WQ User Manual

Configure the Display

Broadcast Keys

Use Broadcast Keys to relay all key presses received by the projector to all other projectors on the
network.

Front IR Enabled

Check this option to enable the front IR sensor.

Wired Keypad Enabled

Check this option to use the wired keypad.

Display Error Messages

Choose how you want to be notified of errors detected in either the incoming signal or projector.
Select Serial Ports to receive messages using RS-232 or RS-422 serial communication only. To hide
error message displays, such as during shows and presentations, select Off.

Language

Choose the available language to use in the projector menus. The change will take effect
immediately.

Diagnostics and Calibration

To access this menu select Configuration > Diagnostics and Calibration.

Select a Test Pattern

1. From the Test Pattern drop-down select the
desired internal test pattern or select Off to
disable.
Or:
2. Use the Test key from the IR remote to cycle
through the test patterns.

Set Grey Level

Use the slide bar to set the level of grey for displaying in the full grey field test pattern.
64 Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)