Lcb-Lens Motor Calibration - Christie Mirage SST Technical Reference

Examples
Disable the green laser:
(LAS+EGRN 0)
Change the red laser drive level to 50%:
(LAS+REDP 500)
Adjust the overall output of the lasers to 80%:
(LAS+POWR 800)
Disable all lasers:
(LAS+EPOW 0)
Enable the blue laser:
(LAS+EBLU 1)
Set the expected maximum ambient temperature to 25°C:
(LAS+MAXA 25)
LCB–Lens Motor Calibration
Calibrates all of the lens motors.
This command is only enabled when the projector is on.
Commands
Command Description
LCB 1 Runs calibration on all lens motors.
LCB+HOME Moves all lens motors back to the center flag for each
axis and sets their respective positions to 0.
LCB+LOCK <0 | 1> Locks all lens motors preventing the lens from moving.
This overrides all other lens functions.
LCB+ZOMR <0 | 1> Programs the lens connector board lens (LCBL) to
indicate that the lens is motorized or non-motorized.
LCB+ZOOM 1 Calibrates the zoom motor.
Examples
Start calibration:
(LCB 1)
Move the lens back to the home position:
(LCB+HOME)
Mirage SST Technical Reference–Serial Commands
020-103005-03 Rev. 1 (01-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
1
—
0 = Unlocks motors (Default)
1 = Locks motors
0 = Lens does not have a zoom
(Default)
1 = Lens has a zoom motor
1
42