Creating A New Channel; Selecting A Channel - Christie Roadie HD+35K User Manual

Shown above is a sample list of channels available when you press the C
Channel list
" ".
The C
NOTE: HAN
Channel List" (refer to
In order to access channels by using the C
below.

3.7.2 Creating a New Channel

To use a new input source with the projector, a new channel must be added to the projector memory so that the
projector responds properly to an input signal from that source in the future. A new channel can be created
automatically, as described here, or it can be copied from an existing channel, and then edited as necessary (see
Section 3.7.5 Copying a Channel
When you select a direct input (Input 1, Input 2, Input 3, Input 4, Input 5, or Input 6), any existing channels
in the projector are searched for matching input and signal parameters. If no match to the incoming input signal
is found in currently-defined channels, a new channel is temporarily created based on factory-defined defaults
for this type of signal. The channel number assigned is the lowest available number from 01-99.
NOTES: 1)
An automatic channel is discarded unless one or more of its parameters are changed, and it does not
appear in the channel list (see below).
characteristics except for the reversal of sync connectors (i.e., H-sync and V-sync, are switched), they are
still defined as distinct channels.
If the incoming signal does match an existing channel, the image is set up and displays as usual, according to
the parameters currently defined for that channel.

3.7.3 Selecting a Channel

Using a Channel
You can normally select a channel at any time by pressing C
appearing in this list, you must edit the channel as described in
this section. Such a channel can still be selected by entering its number as shown below.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Figure 3-19 Channel List
key may display a channel list or not, depending on what you have defined for "Display
Menu Preferences
HAN
later in this section).
3)
later in this section).
key on the remote, you must first create the channels. See
2)
If two channels have the same distinguishing source
You cannot define a new channel without an incoming signal.
HAN
. If you want to prevent a channel from
Section 3.7.7 Editing a Channel Setup
Section 3: Operation
HAN
key. This is typically called the
later in
3-37