Analog Bnc Input Card; Dual Sd/Hd - Sdi Input Card - Christie Entero RPMSP–LED01 Installation Manual

3.8.4 Analog BNC Input Card

This card accepts several types of Sync modes. In 5–wire Sync mode, all 5 BNC connectors are used. If H/C and
V connectors are swapped, this card will still operate normally. An analog graphic source, such as a VGA from a
PC, can be connected. The card can operate in 4–wire Sync mode, which accommodates 4–wire RGBC sources.
The composite Sync cable can be connected to either the H/C BNC or the V BNC. The card supports 3–wire
RGB or YPBPr Sync modes, sometimes called Sync–On–Green (SOG). In this mode, the H/C and V connectors
are not used. The Sync is connected to the Green/Y BNC connector. This card offers no loop–out capability.
There are 2 LEDs on the module faceplate. PWR indicates power has been applied, and the card is initialized.
Signal indicates a valid signal has been detected.
3.8.5 Dual SD/HD – SDI Input Card
This card accepts both standard–definition (SD) and high–definition (HD) serial–digital–interface (SDI) signals
from 1 of 2 SD or HD SDI sources. Both single–link HD and dual–link HD signals are accepted. The card has 2
SD/HD–SDI outputs, each of which is "loop through" for its respective input. There are 3 LEDs on the module
faceplate. PWR indicates power has been applied and the card is initialized, and the 2 Signal LEDs indicate a
valid signal has been detected on the respective input.
3-20 Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)