Diagnostic Trouble Code (Dtc) Check; Diagnostic Trouble Code (Dtc) Clearance; Diagnostic Trouble Code (Dtc) Table - Suzuki GRAND VITARA Owner's Manual

10C-6 Immobilizer Control System:

Diagnostic Trouble Code (DTC) Check

NOTE
To know how to use SUZUKI scan tool in
detail, refer to its operator's manual.
1) Turn the ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located under instrument panel at driver's
seat side.
Special tool
(A): SUZUKI scan tool
(A)
3) Turn the ignition switch to ON position.
4) Check if any DTC is stored in ECM according to the
instructions displayed on SUZUKI scan tool.
5) After completing the check, turn ignition switch to
OFF position, and then disconnect SUZUKI scan
tool from DLC.

Diagnostic Trouble Code (DTC) Table

ECM
NOTE
ECM detects diagnostic trouble code (DTC). Immobilizer control module (ICM) does not.
DTC No.
P1614 Transponder response error
Steering lock unit communication error (for
P1615
vehicle with keyless start system)
Unregistered keyless start control module (for
P1616
vehicle with keyless start system)
S5JB0AA304002
1
I4RS0BA30003-03
Detecting Item

Diagnostic Trouble Code (DTC) Clearance

NOTE
To know how to use SUZUKI scan tool in
detail, refer to its operator's manual.
1) Turn the ignition switch to OFF position,
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located under instrument panel at driver's
seat side.
Special tool
(A): SUZUKI scan tool
(A)
1) Turn the ignition switch to ON position.
2) Clear DTC(s) according to the instructions displayed
on SUZUKI scan tool.
3) After completing the clearance, turn the ignition
switch to OFF position, and then disconnect SUZUKI
scan tool from DLC.
Detecting Condition
Transponder code in the transponder built in
the ignition key cannot be read through
immobilizer control module (ICM).
• While registering the transponder code in
the transponder built in the ignition key in
ECM, the keyless start control module sent
a signal to ECM indicating that the remote
controller ID code could not be registered.
• The remote controller ID code could not be
registered in the keyless start control
module or ECM. And, the registration
procedure of the transponder code in the
transponder built in the ignition key was
terminated forcibly.
ECM detects different ID codes registered in
ECM and keyless start system.
S5JB0AA304003
1
I4RS0BA30003-03
S5JB0AA304004
Immobilizer
Indicator
Lamp
Flash
Flash
Flash