Sliding (Sun) Roof Glass Removal And Installation; Sliding (Sun) Roof Glass Adjustment; Sliding (Sun) Roof Switch Inspection - Suzuki GRAND VITARA Owner's Manual

Sliding (Sun) Roof Glass Removal and
Installation
Removal
1) Open sunshade (1) fully and tilt up sliding roof.
2) Disconnect negative (–) cable at battery.
3) Remove sliding roof covers.
4) Remove sliding roof glass by removing bolts
(TORX® T25) (1).
Installation
For installation, reverse removal procedure, noting the
following points.
1) Tighten glass fixing bolts temporarily.
2) Initialize sliding roof position data referring to
Owner's Manual.
3) Position sliding roof glass by closing sliding roof
glass completely.
4) Tighten glass fixing bolts after sliding roof glass
adjustment referring to "Sliding (Sun) Roof Glass
Adjustment: ".

Sliding (Sun) Roof Glass Adjustment

1) Loosen sliding roof glass fixing screws (at 4
locations) and move sliding roof glass (1) up and
down 2 to 3 times. In this way, sliding roof glass can
be positioned in both vertical and horizontal
directions by elasticity of sliding roof weather strip.
2) Position sunroof glass by such dimensions with
respect to roof panel surface as specified below.
S5JB0A9906002
1
I5JB0A990002-01
1
I5JB0A990003-01
S5JB0A9906003
Sun Roof / T-Top / Convertible Top:
Sliding roof glass position (between glass roof
and roof panel)
"a": 0 mm (0.0 in.)
3) After installing all parts and adjusting properly, check
sunroof for proper operation (open, close and up).

Sliding (Sun) Roof Switch Inspection

Check switch for continuity between terminals as shown
below.
TILT
Switch
Terminal UP
1
2
3
9I-2
I5JB0A990004-01
S5JB0A9906005
1
2
3
SLIDE
N
OPEN
I5JB0A990005-01