Sliding (Sun) Roof Motor Removal And Installation; Sliding (Sun) Roof System Circuit And Motor Inspection - Suzuki GRAND VITARA Owner's Manual

9I-3 Sun Roof / T-Top / Convertible Top:
Sliding (Sun) Roof Motor Removal and
Installation
Removal
1) Remove spot lamp assembly from head lining.
2) Disconnect coupler (3) and remove sliding roof
motor (1) by removing 2 bolts (2).
2
3
Installation
For installation, reverse removal procedure, noting the
following points.
• Connect coupler to sliding roof motor securely.
• Initialize sliding roof position data referring to "How to
reactivate the system to prevent being pinched by the
sunroof" in Sunroof section of Owner's manual.
Sliding (Sun) Roof System Circuit and Motor
Inspection
1) Check that sliding roof switch is in good condition
referring to "Sliding (Sun) Roof Switch Inspection: ".
2) Connect connector to sliding roof switch.
3) Disconnect connector from sliding roof motor.
4) Measure voltage and resistance between each
terminals of sliding roof motor connector (1).
If each voltage and/or resistance are within specified
value, sliding roof system circuit is in good condition
and proceed next step.
If each voltage and/or resistance are out of specified
value, repair sliding roof system circuit.
Sliding roof system circuit specification with
connector disconnected
Measurement Measurement
terminal condition
Ignition switch
5(+) – 7(–) turned OFF and
ON
Ignition switch
8(+) – 7(–)
turned ON
Ignition switch
turned OFF and
sliding roof
9 – 7
switch from OFF
to "SLIDE
OPEN"
S5JB0A9906006
7 – vehicle body
1
I5JB0A990006-01
5) Connect connector to sliding roof motor (1).
6) Measure each voltage between terminals of sliding
S5JB0A9906007
Reference value
10 – 14 V
10 – 14 V
Infinity
↓
0 – 1 Ω
Measurement Measurement
terminal condition
Ignition switch
turned OFF and
10 – 7 sliding roof
switch from OFF
to "TILT UP"
Ignition switch
ground turned OFF
[A]
4 3
10 9 8
[A]: Viewed from harness side
roof motor connector (2) with ignition switch ON.
If each voltage is out of specified value, replace
sliding roof motor.
Sliding roof motor out put voltage
Measurement Measurement
terminal condition
Sliding roof
switch from OFF
9(+) – 7(–) to "SLIDE
OPEN"
Sliding roof
switch from OFF
10(+) – 7(–) to "TILT UP"
[A]
4 3
10 9 8
[A]: Viewed from harness side
Reference value
Infinity
↓
0 – 1 Ω
0 – 1 Ω
1
2 1
7 6 5
I5JB0A990007-01
Reference value
10 – 14 V
(OFF)
↓
0 V
("SLIDE OPEN")
10 – 14 V
(OFF)
↓
0 V
("TILT UP")
1 2
2 1
7 6 5
I5JB0A990008-01