Mazda RX-8 Workshop Manual page 2772

Connect the negative battery cable.
Turn the ignition switch to the ON position with SAS
control module connector and passenger-side air bag
module connector disconnected.
Measure the voltage of SAS control module connector
terminals 1P and 1M of SAS control module harness
side connector.
NOTE:
Measure the voltage while shaking the wiring harness
between the SAS control module and passenger-side
air bag module (inflator No.1).
Is the voltage measured?
INSPECT PASSENGER-SIDE AIR BAG MODULE (INFLATOR
4 NO.1)
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait for 1
min or more.
Connect the SST (Fuel and thermometer checker) or
apply 2 ohms resistance to the passenger-side air bag
module connector terminals 1C and 1D.
Set the SST (fuel and thermometer checker) to 2
ohms.
Except for the passenger-side air bag module
connector, reconnect all disconnected connectors.
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Clear DTCs using the M-MDS. (See
Perform the DTC inspection for the SAS control module
using the M-MDS. (See
Are DTCs B1913, B1925, B1933 and/or B1935
displayed?
INSPECT DTCs
5
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait for
1min or more.
Disconnect the SST (Fuel and thermometer checker)
or the 2 ohms resistance.
CLEARING
DTC DISPLAY.)
side air bag module
(inflator No.1).
No Go to the next step.
YesGo to the next step.
No Replace the passenger-
side air bag module. (See
PASSENGER-SIDE AIR BAG
MODULE
REMOVAL/INSTALLATION.)
DTC.)
YesReplace the SAS control
module.
(See
MODULE
REMOVAL/INSTALLATION.)
No DTC troubleshooting
SAS CONTROL