Mazda RX-8 Workshop Manual page 2831

STEP
VERIFY THAT ALL SAS CONTROL MODULE
1
CONNECTORS ARE CONNECTED WITH SAS
CONTROL MODULE
WARNING:
Handling the air bag system
components improperly can
accidentally deploy the air bag
modules and pre-tensioner seat
belts, which may seriously injure you.
Read the service warnings and
cautions before handling the air bag
system components.
(See
WARNINGS.)
(See
CAUTIONS.)
Turn the ignition switch to the LOCK
position.
Disconnect the negative battery cable
and wait for 1 min or more.
Partially peel back the floor covering.
Are all SAS control module connectors
securely connected?
INSPECT ALL SAS CONTROL MODULE
2
CONNECTORS
Remove the column cover.
Disconnect the clock spring
connector.
Remove the glove compartment.
Disconnect the passenger-side air
bag module connector.
Disconnect the driver and passenger-
side side air bag module connectors.
Disconnect the driver and passenger-
side curtain air bag module
connectors.
Remove the rear door lower trim.
INSPECTION
AIR BAG SYSTEM SERVICE
AIR BAG SYSTEM SERVICE
YesGo to the next step.
No Reconnect the connector properly.
Yes [Present malfunction
diagnosis]
Replace the SAS control
module.
(See SAS CONTROL
MODULE
REMOVAL/INSTALLATION.)
[Past malfunction
diagnosis]
DTC troubleshooting
completed.
No Replace the air bag wiring harness.
ACTION