< Previous Next >
2011 - RX-8 - Transmission/Transaxle
OIL COOLER FLUSHING [SJ6A-EL]
NOTE:
The contaminated cooler line (oil pipes and hoses) and auxiliary cooler must be flushed
completely when AT is overhauled or replaced.
1. Remove the two oil cooler line hoses and apply air pressure of 196 kPa {2.0 kgf/cm
psi} from the return hose (pipe) side.
CAUTION:
Power flushing should be performed very carefully when removing the
accumulated debris from the fluid baffle, otherwise the debris cannot be
removed or the problem becomes even worse.
NOTE:
2
, 28