Mazda RX-8 Workshop Manual page 2858

< Previous Next >
2011 - RX-8 - Restraints
SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
Handling the air bag module improperly can accidentally operate (deploy) the air bag
module, which may seriously injure you. Read the service warnings and cautions before
handling the air bag module. (See
SYSTEM SERVICE
If the side air bag module is installed with debris in the seat back, the foreign material
may be scattered when the side air bag module operates (deploys), causing injury. Verify
that there is no foreign material in the seat back before installing the side air bag module.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the front seat back trim. (See
4. Remove the front seat cushion. (See
5. Remove the clip as shown in the figure.
6. Remove the nuts.
AIR BAG SYSTEM SERVICE
CAUTIONS.)
FRONT SEAT BACK TRIM
FRONT SEAT CUSHION TRIM
WARNINGS.) (See AIR BAG
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)