< Previous Next >
2011 - RX-8 - HVAC
REFRIGERANT LINE REMOVAL/INSTALLATION
1. Remove the battery.
2. Remove the fresh-air duct and air cleaner. (See
3. Remove the windshield washer tank. (See
4. Remove the PCM. (See
5. Remove the EPS control module. (See
6. Remove the front suspension tower bar. (MT) (See
7. Remove the bracket.
8. Discharge the refrigerant from the system. (See
9. Remove the front bumper. (See
10. Do not allow remaining compressor oil in the piping and connecting parts to spill, and remove in the order indicated in
the table.
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal
noise or other malfunction could occur. Always plug open fittings immediately after removing any
refrigeration cycle parts.
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
WINDSHIELD WASHER TANK
PCM REMOVAL/INSTALLATION
EPS CONTROL MODULE
REFRIGERANT
FRONT BUMPER
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
[13B-MSP].)
REMOVAL/INSTALLATION.)
FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION
CHARGING.)
[13B-MSP].)
[MT].)