Mazda RX-8 Workshop Manual page 2889

< Previous Next >
2011 - RX-8 - Restraints
SAS CONTROL MODULE REMOVAL/INSTALLATION
WARNING:
Handling the SAS control module improperly can accidentally deploy the air bag modules
and pre-tensioner seat belt, which may seriously injure you. Read the service warnings
and cautions before handling the air bag module. (See
WARNINGS.) (See
CAUTION:
Handling the SAS control module improperly can accidentally deploy the air bag modules
and pre-tensioner seat belt, which may seriously injure you. If configuration is not
completed before removing the SAS control module, DTC B1342 will be displayed.
1. Perform SAS control module configuration when replacing it. (See
CONFIGURATION.)
2. Turn the ignition switch to the LOCK position.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove the following parts:
a. Console (See
b. Glove compartment (See
c. Side panel (See
d. Lower panel (See
e. Column cover (See
f. Steering shaft (See
g. A-pillar trim (See
h. Dashboard (See
5. Remove in the order indicated in the table.
AIR BAG SYSTEM SERVICE
CONSOLE REMOVAL/INSTALLATION.)
GLOVE COMPARTMENT
SIDE PANEL REMOVAL/INSTALLATION.)
LOWER PANEL REMOVAL/INSTALLATION.)
COLUMN COVER
STEERING WHEEL AND COLUMN
A-PILLAR TRIM REMOVAL/INSTALLATION.)
DASHBOARD REMOVAL/INSTALLATION.)
AIR BAG SYSTEM SERVICE
CAUTIONS.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
SAS CONTROL MODULE