Mazda RX-8 Workshop Manual page 2576

< Previous Next >
2011 - RX-8 - HVAC
A/C UNIT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See
3. Drain the engine coolant. (See
4. Remove the following parts:
a. Console (See
b. Ashtray
c. Glove compartment (See
d. Side panel (See
e. Lower panel (See
f. Column cover (See
g. Center panel unit (See
h. Steering shaft installation nuts (See
REMOVAL/INSTALLATION.)
i. A-pillar trim (See
j. A/C amplifier (See
CONDITIONER].) (See
CONDITIONER].)
k. TCM (AT) (See
l. Auto light/wiper control module (See
REMOVAL/INSTALLATION.)
m. Door lock control module (See
REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND START
n. Dashboard (See
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered
and abnormal noise or other malfunction could occur. Always plug open fittings
immediately after removing any refrigeration cycle parts.
ENGINE COOLANT REPLACEMENT
CONSOLE REMOVAL/INSTALLATION.)
GLOVE COMPARTMENT
SIDE PANEL REMOVAL/INSTALLATION.)
LOWER PANEL REMOVAL/INSTALLATION.)
COLUMN COVER
CENTER PANEL UNIT
A-PILLAR TRIM REMOVAL/INSTALLATION.)
A/C AMPLIFIER REMOVAL/INSTALLATION [FULL-AUTO AIR
A/C AMPLIFIER REMOVAL/INSTALLATION [MANUAL AIR
TCM REMOVAL/INSTALLATION
DOOR LOCK CONTROL MODULE
DASHBOARD REMOVAL/INSTALLATION.)
REFRIGERANT
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
STEERING WHEEL AND COLUMN
[SJ6A-EL].)
AUTO LIGHT/WIPER CONTROL MODULE
CHARGING.)
[13B-MSP].)
SYSTEM].)