Mazda RX-8 Workshop Manual page 2882

module.
Pre-tensioner seat belt
1. Remove the pre-tensioner seat belt. (See
WARNING:
If the pre-tensioner seat belt is not properly installed to the tire, serious injury may occur
when the pre-tensioner part is operated (deployed). When installing the pre-tensioner seat
belt to the tire, make sure the pre-tensioner part is inside the tire.
2. Connect the SST (Adapter harness) to the pre-tensioner seat belt as shown in the figure.
3. Put the pre-tensioner seat belt inside the tire and secure it to the tire by wrapping a wire (cross section
2
1.25 mm {0.002 in
FRONT SEAT BELT
2
} or more) through the tire and the bolt installation holes at least 4 times.
REMOVAL/INSTALLATION.)