< Previous Next >
2011 - RX-8 - Steering
EPS CONTROL MODULE REMOVAL/INSTALLATION
CAUTION:
If the EPS control module is replaced, set the EPS system to the neutral position. If not set
to the neutral position, the system may not operate correctly. (See
POSITION
Do not drop the EPS control module. Replace the EPS control module if it subjected to an
impact.
1. Remove the following parts:
a. Engine cover. (See
b. Battery cover. (See
c. PCM cover (See
d. PCM (See
e. PCM bracket No.1 (See
f. PCM bracket No.2 (See
g. PCM bracket No.3 (See
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, set the EPS system to the neutral position. (See
POSITION
SETTING.)
SETTING.)
ENGINE COVER REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
PCM REMOVAL/INSTALLATION
PCM REMOVAL/INSTALLATION
PCM REMOVAL/INSTALLATION
PCM REMOVAL/INSTALLATION
PCM REMOVAL/INSTALLATION
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
EPS SYSTEM NEUTRAL
EPS SYSTEM NEUTRAL