Mazda RX-8 Workshop Manual page 2589

< Previous Next >
2011 - RX-8 - HVAC
A/C COMPRESSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See
3. Remove the fresh-air duct and air cleaner. (See
REMOVAL/INSTALLATION
4. Remove the drive belt. (See
5. Do not allow remaining compressor oil in the A/C compressor and pipes to spill, and remove
in the order indicated in the table.
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability will
be lowered and abnormal noise or other malfunction could occur.Always plug
open fittings immediately after removing any refrigeration cycle parts.
[13B-MSP].)
DRIVE BELT REPLACEMENT
REFRIGERANT CHARGING.)
INTAKE-AIR SYSTEM
[13B-MSP].)