< Previous Next >
2011 - RX-8 - HVAC
SOLAR RADIATION SENSOR REMOVAL/INSTALLATION [FULL-AUTO AIR
CONDITIONER]
1. Disconnect the negative battery cable.
2. Pry the solar radiation sensor from the dashboard using a flathead screwdriver wrapped with
protective tape.
3. Remove in the order indicated in the table.
CAUTION:
After the solar radiation sensor removal, the sensor connector could fall in the
dashboard making the installation difficult. Therefore, hold the rooted end of
the sensor connector using a clip or similar tool to prevent it from falling.
1Solar radiation sensor connector
2Solar radiation sensor
4. Install in the reverse order of removal.
< Previous Next >