Mazda RX-8 Workshop Manual page 2815

INSPECT THE WIRING HARNESS BETWEEN THE SAS CONTROL
3
MODULE AND DRIVER-SIDE SIDE AIR BAG SENSOR FOR A
SHORT CIRCUIT TO THE POWER SUPPLY
Connect the negative battery cable.
Turn the ignition switch to the ON position with SAS
control module connector and driver-side side air bag
sensor connector disconnected.
Measure the voltage of SAS control module connector
terminals 2Z and 2AA of SAS control module harness
side connector.
NOTE:
Measure the voltage while shaking the wiring harness
between the SAS control module and driver-side side
air bag sensor.
Is the voltage measured?
PERFORM DTC INSPECTION
4
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait for 1
min or more.
Reconnect all disconnected connectors
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Clear DTCs using the M-MDS. (See
Perform the DTC inspection for the SAS control module
using the M-MDS. (See
Are DTCs B2444 and/or U2017 displayed?
< Previous Next >
DTC DISPLAY.)
© 2010 Mazda North American Operations, U.S.A.
CLEARING DTC.)
YesReplace the wiring harness
between the SAS control
module and the driver-side
side air bag sensor.
No Replace the driver-side
side air bag sensor, then
go to the next step.
(See SIDE AIR BAG
MODULE
REMOVAL/INSTALLATION.)
YesReplace the SAS control
module.
(See SAS CONTROL
MODULE
REMOVAL/INSTALLATION.)
No DTC troubleshooting
completed.
Back to Top