Mazda RX-8 Workshop Manual page 3009

CONTINUITY
Measure the continuity of the wiring harness
between coil antenna connector terminal A
and ground.
Is there continuity?
8 VERIFY AFTER REPAIR
Turn the ignition switch to the LOCK
position.
Disconnect the negative battery cable.
Reconnect the disconnected connectors.
Connect the negative battery cable.
Clear DTCs using the M-MDS.
(See CLEARING DTC [IMMOBILIZER
SYSTEM].)
Verify DTCs using the M-MDS.
(See DTC INSPECTION (IMMOBILIZER
SYSTEM) [IMMOBILIZER
Are DTCs output again?
9 VERIFY THAT NO OTHER DTCs ARE PRESENT
Verify if other DTCs are displayed.
Are any other DTCs output?
< Previous Next >
SYSTEM].)
Keyless control module:
B1681
PCM: P1260
© 2010 Mazda North American Operations, U.S.A.
No Replacing the coil antenna.
(See COIL ANTENNA
REMOVAL/INSTALLATION
Go to the next step
Yes Replace the keyless control module
and program the immobilizer
system-related parts.
(See KEYLESS CONTROL MODULE
REMOVAL/INSTALLATION.)
(See IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH ADVANCED KEYLESS ENTRY
AND START
(See IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH KEYLESS ENTRY
Go to the next step.
No Go to the next step.
YesPerform the corresponding DTC inspection.
No DTC troubleshooting completed.
.)
SYSTEM].)
SYSTEM].)
Back to Top