Mazda RX-8 Workshop Manual page 2836

Connect the negative battery cable.
Turn the ignition switch to the ON position with SAS
control module connector and seat track position
sensor connector disconnected.
Measure the voltage of SAS control module connector
terminals 2W and 2X of SAS control module harness
side connector.
NOTE:
Measure the voltage while shaking the wiring harness
between the SAS control module and seat track
position sensor.
Is the voltage measured?
PERFORM DTC INSPECTION
4
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait for 1
min or more.
Reconnect all disconnected connectors
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Clear DTCs using the M-MDS. (See
Perform the DTC inspection for the SAS control module
using the M-MDS. (See
Are DTCs C1947, C1948 and/or C1981 displayed?
< Previous Next >
DTC DISPLAY.)
© 2010 Mazda North American Operations, U.S.A.
CLEARING DTC.)
module and the seat track
position sensor.
No Replace the seat track
position sensor, then go to
the next step.
YesReplace the SAS control
module.
(See SAS CONTROL
MODULE
REMOVAL/INSTALLATION.)
No DTC troubleshooting
completed.
Back to Top