Mazda RX-8 Workshop Manual page 2964

Inspect the wiring harness between
keyless antenna (interior, front)
terminal A and keyless control module
terminal 1O, and keyless antenna
(interior, front) terminal B and keyless
control module terminal 1P for the
following:
Is there continuity?
INSPECT KEYLESS CONTROL MODULE
2
Turn the ignition switch to the ON
position.
Is the DTC displayed?
< Previous Next >
Short to ground
Short to power supply
Open circuit
M-MDS: B112A
© 2010 Mazda North American Operations, U.S.A.
[WITH ADVANCED
KEYLESS ENTRY AND
START
Go to next step.
No Repair the wiring harness
between the keyless
antenna (interior, front)
and keyless control
module.
Go to next step.
YesReplace the keyless control module and
perform the resetting procedure for the
advanced keyless system when replacing
the keyless control module.
(See KEYLESS CONTROL MODULE
REMOVAL/INSTALLATION.)
(See CARD KEY ID CODE REGISTRATION
[WITH ADVANCED KEYLESS ENTRY AND
START SYSTEM])
(See STEERING LOCK UNIT ID CODE
REGISTRATION [WITH ADVANCED
KEYLESS ENTRY AND START
(See KEYLESS CONTROL MODULE
CONFIGURATION)
(See IMMOBILIZER SYSTEM-RELATED
PARTS PROGRAMMING [WITH ADVANCED
KEYLESS ENTRY AND START
No DTC troubleshooting completed.
SYSTEM])
SYSTEM])
SYSTEM])
Back to Top