Mazda RX-8 Workshop Manual page 2336

< Previous Next >
2011 - RX-8 - Transmission/Transaxle
SELECTOR LEVER REMOVAL/INSTALLATION
1. Remove the engine cover. (See
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the following parts.
a. Ashtray (See
b. Console (See
c. Glove compartment (See
d. Side panel (See
e. Lower panel (See
f. Column cover (See
g. Driver-side air bag module (See
h. Steering shaft (See
i. Instrument cluster (See
j. A-pillar trim (See
k. Dashboard (See
l. SAS control module (See
m. Exhaust pipe (See
5. Shift the selector lever to the P position.
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. After installation, carry out the shift lock inspection and key interlock inspection.
(See SHIFT LOCK INSPECTION.)
(See KEY INTERLOCK
ENGINE COVER REMOVAL/INSTALLATION
CONSOLE REMOVAL/INSTALLATION.)
CONSOLE REMOVAL/INSTALLATION.)
GLOVE COMPARTMENT
SIDE PANEL REMOVAL/INSTALLATION.)
LOWER PANEL REMOVAL/INSTALLATION.)
COLUMN COVER REMOVAL/INSTALLATION.)
DRIVER-SIDE AIR BAG MODULE
STEERING WHEEL AND COLUMN
INSTRUMENT CLUSTER
A-PILLAR TRIM REMOVAL/INSTALLATION.)
DASHBOARD REMOVAL/INSTALLATION.)
SAS CONTROL MODULE
EXHAUST SYSTEM REMOVAL/INSTALLATION
INSPECTION.)
[13B-MSP].)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
[13B-MSP].)