Mazda RX-8 Workshop Manual page 2978

connector.
Inspect the wiring harness between
keyless control module connector
terminal 3H and steering lock unit
connector terminal G for the
following:?
Is the wiring harness normal?
INSPECT STEERING LOCK UNIT
2
Turn the ignition switch to the ON
position.
Is the DTC displayed?
INSPECT KEYLESS CONTROL MODULE
3
Turn the ignition switch to the ON
position.
Is the DTC displayed?
Short to body
ground
Short to power
supply
Open circuit
M-MDS: B1093
M-MDS: B1093
(See STEERING LOCK UNIT
ID CODE REGISTRATION
[WITH ADVANCED KEYLESS
ENTRY AND START
SYSTEM])
Go to the next step.
No Repair the wiring harness
between the steering lock
unit and keyless control
module.
Go to next step.
Yes Replace the steering lock unit
and perform the resetting
procedure for the steering
lock unit.
(See STEERING WHEEL AND
COLUMN
REMOVAL/INSTALLATION.)
(See STEERING LOCK UNIT
ID CODE REGISTRATION
[WITH ADVANCED KEYLESS
ENTRY AND START
SYSTEM])
Go to the next step.
No DTC troubleshooting completed.
YesReplace the keyless control module and
perform the resetting procedure for the
advanced keyless system when replacing the
keyless control module.
(See KEYLESS CONTROL MODULE
REMOVAL/INSTALLATION.)
(See CARD KEY ID CODE REGISTRATION
[WITH ADVANCED KEYLESS ENTRY AND
START SYSTEM])
(See STEERING LOCK UNIT ID CODE
REGISTRATION [WITH ADVANCED KEYLESS
ENTRY AND START
(See KEYLESS CONTROL MODULE
CONFIGURATION)
SYSTEM])