Mazda RX-8 Workshop Manual page 2768

Disconnect the negative battery cable and wait for 1min or more.
Connect the leads of the SST (Fuel and thermometer checker) or apply 2
ohms resistance to clock spring connector terminals 3A and 3B.
Set the resistance of the SST (Fuel and thermometer checker) to the 2
ohms position.
Except for the clock spring connector, reconnect all disconnected connectors.
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Clear DTCs using the M-MDS. (See
Perform the DTC inspection for the SAS control module using the M-MDS.
(See DTC
Are DTCs B1913, B1916, B1932 and/or B1934 displayed?
INSPECT DTCs
6
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait for 1min or more.
Disconnect the SST (Fuel and thermometer checker) or the 2 ohms
resistance.
Connect the clock spring connector.
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Clear DTCs using the M-MDS. (See
Perform the DTC inspection for the SAS control module using the M-MDS.
(See DTC
Is DTC B1913, B1916, B1932 and/or B1934 displayed again?
< Previous Next >
DISPLAY.)
DISPLAY.)
© 2010 Mazda North American Operations, U.S.A.
CLEARING DTC.)
CLEARING DTC.)
No Replace the driver-side air
bag module.
(See DRIVER-SIDE AIR
BAG MODULE
REMOVAL/INSTALLATION.)
YesReplace the SAS control
module.
(See SAS CONTROL
MODULE
REMOVAL/INSTALLATION.)
No DTC troubleshooting
completed.
Back to Top