Mazda RX-8 Workshop Manual page 2894

< Previous Next >
2011 - RX-8 - Restraints
SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION
CAUTION:
When the seat weight sensor control module is replaced with a new one, perform the seat
weight sensor calibration using the M-MDS. (See
1. Turn the ignition switch to the LOCK position.
2. Remove the battery cover.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove the front passenger's seat (See
5. Remove in the order indicated in the table.
1Connector
2Nut
3Seat weight sensor control module
6. Install in the reverse order of removal.
SEAT WEIGHT SENSOR
FRONT SEAT REMOVAL/INSTALLATION.)
CALIBRATION.)