Mazda RX-8 Workshop Manual page 2973

connector.
Inspect the wiring harness
between the keyless control
module connector terminal 3E and
steering lock unit terminal A for
the following:
Is there continuity?
INSPECT KEYLESS CONTROL MODULE
2
Turn the ignition switch to the ON
position.
Is the DTC displayed?
< Previous Next >
Short to ground
Short to power
supply
Open circuit
M-MDS: B2170
© 2010 Mazda North American Operations, U.S.A.
REMOVAL/INSTALLATION.)
(See STEERING LOCK UNIT ID CODE
REGISTRATION [WITH ADVANCED KEYLESS
ENTRY AND START
No Repair the wiring harness between the steering
lock unit and keyless control module.
YesReplace the keyless control module and
perform the resetting procedure for the
advanced keyless system when replacing the
keyless control module.
(See KEYLESS CONTROL MODULE
REMOVAL/INSTALLATION.)
(See CARD KEY ID CODE REGISTRATION
[WITH ADVANCED KEYLESS ENTRY AND
START SYSTEM])
(See STEERING LOCK UNIT ID CODE
REGISTRATION [WITH ADVANCED KEYLESS
ENTRY AND START
(See KEYLESS CONTROL MODULE
CONFIGURATION)
(See IMMOBILIZER SYSTEM-RELATED PARTS
PROGRAMMING [WITH ADVANCED KEYLESS
ENTRY AND START
No DTC troubleshooting completed.
SYSTEM])
SYSTEM])
SYSTEM])
Back to Top