additional key.
(See
IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH KEYLESS ENTRY
(See
IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH ADVANCED KEYLESS ENTRY
AND START
Using the registered key, turn the
ignition switch to the ON position.
Verify the DTC using the M-MDS.
5 VERIFY WHETHER MALFUNCTION IS IN KEY
OR COIL
Using another valid key, turn the
ignition switch to the ON position.
Verify the DTC using the M-MDS.
6 INSPECT KEYLESS CONTROL MODULE
Using the registered key, turn the
ignition switch to the ON position.
< Previous Next >
SYSTEM].)
SYSTEM].)
Is B1600/P1260
displayed again?
Is B1600/P1260
displayed again?
Is B1600/P1260
displayed again?
No
Dispose of the malfunctioning key.
Register a new key if necessary.
(See
IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH KEYLESS ENTRY
(See
IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH ADVANCED KEYLESS
ENTRY AND START
YesReplace the coil, then go to the next step.
(See
COIL ANTENNA REMOVAL/INSTALLATION
No
Dispose of the malfunctioning key.
Register a new key if necessary.
(See
IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH KEYLESS ENTRY
(See
IMMOBILIZER SYSTEM-
RELATED PARTS PROGRAMMING
[WITH ADVANCED KEYLESS
ENTRY AND START
YesReplace the keyless control module and perform
procedures for when replacing the keyless control
module only.
(See
KEYLESS CONTROL MODULE
REMOVAL/INSTALLATION.)
(See
IMMOBILIZER SYSTEM-RELATED PARTS
PROGRAMMING [WITH KEYLESS ENTRY
(See
IMMOBILIZER SYSTEM-RELATED PARTS
PROGRAMMING [WITH ADVANCED KEYLESS
ENTRY AND START
No DTC troubleshooting completed.
SYSTEM].)
SYSTEM].)
SYSTEM].)
SYSTEM].)
SYSTEM].)
SYSTEM].)
Back to Top
.)