Mazda RX-8 Workshop Manual page 2305

< Previous Next >
2011 - RX-8 - Transmission/Transaxle
CONTROL VALVE BODY INSTALLATION [SJ6A-EL]
On-Vehicle Installation
CAUTION:
When installing the control valve body component, do not put the coupler component in
the open space of the separate plate in the control valve body component.
Do not pinch the coupler component between the separate plate and the control valve
body component.
1. Install the accumulator valve and compression springs to the transmission case.
CAUTION:
Do not to damage the O-ring and accumulator piston.
2. Coat the new O-rings with ATF, and install it to the accumulator piston (C-3).
3. Install the accumulator piston (C-3) and the compression spring to the transmission case.