Mazda RX-8 Workshop Manual page 2579

(See Evaporator Temperature Sensor Disassembly
(See Evaporator Temperature Sensor Assembly
7 Polyurethane foam (2)
8 Bracket (1)
9 Bracket (2)
10Heater core
11Evaporator pipe
12A/C amplifier
13Airflow mode actuator
14Airflow mode link set
15Airflow mode main link
16Air mix actuator
17Air mix link set
18A/C case (1)
19A/C case (2)
20Adhesive polyurethane
21Expansion valve
22Evaporator
Evaporator Temperature Sensor Disassembly Note
1. Mark the installation positions (2 locations) for the sensor clamps used to install the evaporator temperature sensor to the
evaporator, and the position for the tip of the evaporator temperature sensor.
2. Remove the evaporator temperature sensor.
Evaporator Temperature Sensor Assembly Note
When evaporator is replaced
1. Assemble the evaporator temperature sensor as shown in the figure.
Note.)
Note.)