Table 7-3. Watchdog Timer Exception Behavior - IBM PPC440X5 CPU Core User Manual

User's Manual
PPC440x5 CPU Core
avoid another Watchdog Timer interrupt due to the same exception (unless TCR[WIE] is cleared instead).
Watchdog Timer Interrupt on page 192 provides more information on the handling of Watchdog Timer inter-
rupts.
If TSR[WIS] is already 1 at the time of the next Watchdog Timer exception, then the action to take depends
on the value of the Watchdog Reset Control (TRC) field of the TCR. If TCR[WRC] is non-zero, then the value
of the TCR[WRC] field will be copied into TSR[WRS], TCR[WRC] will be cleared, and a core reset will occur
(see PPC440x5 Core State After Reset on page 85 for more information on core behavior when reset).
Note that once software has set TCR[WRC] to a non-zero value, it cannot be reset by software; this feature
prevents errant software from disabling the Watchdog Timer reset capability.
Table 7-3 summarizes the action to be taken upon a Watchdog Timer exception according to the values of
TSR[ENW] and TSR[WIS].

Table 7-3. Watchdog Timer Exception Behavior

TSR[ENW] TSR[WIS]
0 0
0 1
1 0
1 1
A typical system usage of the Watchdog Timer function is to enable the Watchdog Timer interrupt and the
Watchdog Timer reset function in the TCR (and MSR), and to start out with both TSR[ENW] and TSR[WIS]
clear. Then, a recurring software loop of reliable duration (or perhaps the interrupt handler for a periodic inter-
rupt such as the Fixed Interval Timer interrup) performs a periodic check of system integrity. Upon successful
completion of the system check, software clears TSR[ENW], thereby ensuring that a minimum of one full
Watchdog Timer period and a maximum of two full Watchdog Timer periods must expire before an enabled
Watchdog Timer exception will occur.
If for some reason the recurring software loop is not successfully completed (and TSR[ENW] thus not
cleared) during this period of time, then an enabled Watchdog Timer exeption will occur. This will set
TSR[WIS] and a Watchdog Timer interrupt will occur (if enabled by both TCR[WIE] and MSR[CE]). The
occurrence of a Watchdog Timer interrupt in this kind of system is interpreted as a "system error", insofar as
the system was for some reason unable to complete the periodic system integrity check in time to avoid the
enabled Watchdog Timer exception. The action taken by the Watchdog Timer interrupt handler is of course
system-dependent, but typically the software will attempt to determine the nature of the problem and correct it
if possible. If and when the system attempts to resume operation, the software would typically clear both
TSR[WIS] and TSR[ENW], thus providing a minimum of another full Watchdog Timer period for a new system
integrity check to occur.
Finally, if for some reason the Watchdog Timer interrupt is disabled, and/or the Watchdog Timer interrupt
handler is unsuccessful in clearing TSR[WIS] and TSR[ENW] prior to another Watchdog Timer exception,
then the next exception will cause a processor reset operation to occur, according to the value of TCR[WRC].
Page 214 of 589
Action upon Watchdog Timer exception
Set TSR[ENW] to 1
Set TSR[ENW] to 1
Set TSR[WIS] to 1. If Watchdog Timer interrupts are enabled (TCR[WIE]=1 and
MSR[CE]=1), then interrupt.
Cause Watchdog Timer reset action specified by TCR[WRC].
Reset will copy pre-reset TCR[WRC] into TSR[WRS], then clear TCR[WRC].
Preliminary
timers.fm.
September 12, 2002