Related Manuals for IBM 9125-F2C
Summary of Contents for IBM 9125-F2C
- Page 1 Power Systems IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
- Page 3 Power Systems IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
- Page 4 Before using this information and the product it supports, read the information in “Safety notices” on page v, “Notices” on page 5, the IBM Systems Safety Notices manual, G229-9054, and the IBM Environmental Notices and User Guide, Z125–5823. Before using this information and the product it supports, read the information in “Safety notices” on page v and “Notices”...
-
Page 5: Table Of Contents
Removing the bulk power flexible Terms and conditions . . 13 service processor (FSP) card battery . . 1 Notices ....5 Trademarks . © Copyright IBM Corp. 2015... - Page 6 IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
-
Page 7: Safety Notices
You should also refer to the safety information documentation any time you do not clearly understand any safety information in the U.S. English publications. Replacement or additional copies of safety information documentation can be obtained by calling the IBM Hotline at 1-800-300-8751. - Page 8 Electrical voltage and current from power, telephone, and communication cables are hazardous. To avoid a shock hazard: v Connect power to this unit only with the IBM provided power cord. Do not use the IBM provided power cord for any other product.
- Page 9 Observe the following precautions when working on or around your IT rack system: v Heavy equipment–personal injury or equipment damage might result if mishandled. v Always lower the leveling pads on the rack cabinet. v Always install stabilizer brackets on the rack cabinet. v To avoid hazardous conditions due to uneven mechanical loading, always install the heaviest devices in the bottom of the rack cabinet.
- Page 10 Pack the rack cabinet in the original packaging material, or equivalent. Also lower the leveling pads to raise the casters off of the pallet and bolt the rack cabinet to the pallet. (R002) (L001) (L002) viii IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
- Page 11 (L003) All lasers are certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter J for class 1 laser products. Outside the U.S., they are certified to be in compliance with IEC 60825 as a class 1 laser product.
- Page 12 Exchange only with the IBM-approved part. Recycle or discard the battery as instructed by local regulations. In the United States, IBM has a process for the collection of this battery. For information, call 1-800-426-4333. Have the IBM part number for the battery unit available when you call. (C003)
-
Page 13: Removing The Bulk Power Flexible Service Processor (Fsp) Card Battery
Removing the bulk power flexible service processor (FSP) card battery ® This procedure describes how to remove the lithium battery used in the FSP card for the IBM Power Supercomputer (9125-F2C). The FSP card is located in the bulk power unit. About this task The FSP card battery must be removed and recycled or discarded when the bulk power unit is removed and replaced with a functional bulk power unit. - Page 14 Figure 2. FSP Card assembly 3. Slide the lithium battery out from the retaining clip. Figure 3. FSP card battery 4. Recycle or discard the batteries as instructed by local regulations. IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
- Page 15 Figure 4. FSP battery Removing the bulk power flexible service processor (FSP) card battery...
- Page 16 IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
-
Page 17: Notices
All statements regarding the manufacturer's future direction or intent are subject to change or withdrawal without notice, and represent goals and objectives only. The manufacturer's prices shown are the manufacturer's suggested retail prices, are current and are subject to change without notice. Dealer prices may vary. © Copyright IBM Corp. 2015... -
Page 18: Trademarks
IBM, the IBM logo, and ibm.com are trademarks or registered trademarks of International Business Machines Corp., registered in many jurisdictions worldwide. Other product and service names might be trademarks of IBM or other companies. A current list of IBM trademarks is available on the web at Copyright and trademark information at www.ibm.com/legal/copytrade.shtml. - Page 19 Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment.
- Page 20 Declaration: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may need to perform practical action. IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
- Page 21 Um dieses sicherzustellen, sind die Geräte wie in den Handbüchern beschrieben zu installieren und zu betreiben. Des Weiteren dürfen auch nur von der IBM empfohlene Kabel angeschlossen werden. IBM übernimmt keine Verantwortung für die Einhaltung der Schutzanforderungen, wenn das Produkt ohne Zustimmung von IBM verändert bzw.
-
Page 22: Class B Notices
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions... - Page 23 Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Proper cables and connectors are available from IBM-authorized dealers. IBM is not responsible for any radio or television interference caused by unauthorized changes or modifications to this equipment.
- Page 24 Confirmed Harmonics Guideline with Modifications (products greater than 20 A per phase) IBM Taiwan Contact Information Electromagnetic Interference (EMI) Statement - Korea Germany Compliance Statement Deutschsprachiger EU Hinweis: Hinweis für Geräte der Klasse B EU-Richtlinie zur Elektromagnetischen Verträglichkeit IBM Power 775 Supercomputer (9125-F2C) bulk power FSP card battery removal instructions...
-
Page 25: Terms And Conditions
Permissions for the use of these publications are granted subject to the following terms and conditions. Applicability: These terms and conditions are in addition to any terms of use for the IBM website. Personal Use: You may reproduce these publications for your personal, noncommercial use provided that all proprietary notices are preserved. - Page 26 IBM reserves the right to withdraw the permissions granted herein whenever, in its discretion, the use of the publications is detrimental to its interest or, as determined by IBM, the above instructions are not being properly followed. You may not download, export or re-export this information except in full compliance with all applicable laws and regulations, including all United States export laws and regulations.
- Page 28 Printed in USA...