Chapter 8 Monitoring Radius; Monitoring Override Settings Of Radius Ietf Attributes - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Chapter 8
Monitoring RADIUS

Monitoring Override Settings of RADIUS IETF Attributes

Purpose
This chapter describes how to monitor the RADIUS attributes, RADIUS
dynamic-request server, and RADIUS relay.
RADIUS topics are described in the following sections:
Monitoring Override Settings of RADIUS IETF Attributes on page 303
Monitoring the NAS-Port-Format RADIUS Attribute on page 304
Monitoring the Calling-Station-Id RADIUS Attribute on page 305
Monitoring the NAS-Identifier RADIUS Attribute on page 305
Monitoring the Format of the Remote-Circuit-ID for RADIUS on page 306
Monitoring the Delimiter Character in the Remote-Circuit-ID for
RADIUS on page 306
Monitoring the Acct-Session-Id RADIUS Attribute on page 306
Monitoring the DSL-Port-Type RADIUS Attribute on page 307
Monitoring the Connect-Info RADIUS Attribute on page 307
Monitoring the NAS-Port-ID RADIUS Attribute on page 307
Monitoring Included RADIUS Attributes on page 308
Monitoring Ignored RADIUS Attributes on page 310
Setting the Baseline for RADIUS Dynamic-Request Server Statistics on page 310
Monitoring RADIUS Dynamic-Request Server Statistics on page 311
Monitoring the Configuration of the RADIUS Dynamic-Request Server on page 312
Setting a Baseline for RADIUS Relay Statistics on page 313
Monitoring RADIUS Relay Server Statistics on page 313
Monitoring the Configuration of the RADIUS Relay Server on page 315
Monitoring the Status of RADIUS Relay UDP Checksums on page 316
Monitoring the Status of ICR Partition Accounting on page 316
Display the current override setting for RADIUS IETF attributes. You can monitor the
NAS-IP-Address [4], NAS-Port-Id [87], Calling-Station-Id [31], and NAS-Identifier [32]
attributes.
Monitoring Override Settings of RADIUS IETF Attributes
303