Juniper JUNOS OS 10.3 - SOFTWARE Manual page 2397

Table 297: show route terse Output Fields (continued)
Field Name Field Description
Protocol through which the route was learned:
P
Preference value of the route. In every routing metric except for the BGP
Prf
value is preferred. In order to use common comparison routines, Junos OS stores the 1's complement
of the
the
Route 2 is preferred because if has a higher
First metric value in the route. For routes learned from BGP, this is the MED metric.
Metric 1
Second metric value in the route. For routes learned from BGP, this is the IGP metric.
Metric 2
Next hop to the destination. An angle bracket (>) indicates that the route is the selected route.
Next hop
AS path through which the route was learned. The letters at the end of the AS path indicate the path
AS path
origin, providing an indication of the state of the route at the point at which the AS path originated:
Copyright © 2010, Juniper Networks, Inc.
—Aggregate
A
—BGP
B
C —CCC
D —Direct
—GMPLS
G
—IS-IS
I
—L2CKT, L2VPN, LDP, Local
L
—Kernel
K
M —MPLS, MSDP
—OSPF
O
—PIM
P
—RIP, RIPng
R
—Static
S
T —Tunnel
value in the
LocalPref Preference2
value is -101. If the
Preference2
—IGP.
I
—EGP.
E
? —Incomplete; typically, the AS path was aggregated.
Chapter 74: Operational Commands for Layer 3 Protocols
field. For example, if the
value for Route 2 is 155, the
LocalPref
value and a lower
LocalPref
attribute, a lesser
LocalPref
value for Route 1 is 100,
LocalPref
value is -156.
Preference2
value.
Preference2
2301