Upstream-Interface - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos

upstream-interface

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
2004
®
OS for EX Series Ethernet Switches, Release 10.3
upstream-interface [ interface-names ];
[edit logical-systems logical-system-name routing-instances routing-instance-name
routing-options multicast pim-to-igmp-proxy],
[edit logical-systems logical-system-name routing-instances routing-instance-name
routing-options multicast pim-to-mld-proxy],
[edit logical-systems logical-system-name routing-options multicast pim-to-igmp-proxy],
[edit logical-systems logical-system-name routing-options multicast pim-to-mld-proxy],
[edit routing-instances routing-instance-name routing-options multicast pim-to-igmp-proxy],
[edit routing-instances routing-instance-name routing-options multicast pim-to-mld-proxy],
[edit routing-options multicast pim-to-igmp-proxy],
[edit routing-options multicast pim-to-mld-proxy]
Statement introduced in Junos OS Release 9.6.
Statement introduced in Junos OS Release 9.6 for EX Series switches.
Configure at least one, but not more than two, upstream interfaces on the rendezvous
point (RP) routing device that resides between a customer edge–facing Protocol
Independent Multicast (PIM) domain and a core-facing PIM domain. The RP routing
device translates PIM join or prune messages into corresponding IGMP report or leave
messages (if you include the
report or leave messages (if you include the
device then proxies the IGMP or MLD report or leave messages to one or both upstream
interfaces to forward IPv4 multicast traffic (for IGMP) or IPv6 multicast traffic (for MLD)
across the PIM domains.
—Names of one or two upstream interfaces to which the RP routing
interface-names
device proxies IGMP or MLD report or leave messages for transmission of multicast
traffic across PIM domains. You can specify a maximum of two upstream interfaces
on the RP routing device. To configure a set of two upstream interfaces, specify the
full interface names, including all physical and logical address components, within
square brackets ( [ ] ). For details about specifying interfaces, see the Junos Network
Interfaces Configuration Guide.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring PIM-to-IGMP Message Translation
Configuring PIM-to-MLD Message Translation
pim-to-igmp-proxy statement), or into corresponding MLD
pim-to-mld-proxy
Copyright © 2010, Juniper Networks, Inc.
statement). The routing