Installing the Ribbon
As noted previously, when printing in thermal
transfer mode, the printer requires a ribbon.
Use the following procedure to install a new
ribbon.
The thermal transfer mode is selected
through the printer menu system. The main
menu is accessed via the secondary
operator panel. Refer to the "Configuring
the Printer" chapter in the
complete instructions in how to access and
use the secondary operator panel.
Press ON LINE/PAUSE to place the
printer in the off line mode.
2
Open the media supply door.
3
Rotate the printhead latch
counterclockwise to unlatch, and raise
the printhead.
Lower the hinge plate.
4
Place the new ribbon supply roll on the
supply hub.
Operator' s Guide
note
Setup Guide
for
Media
Supply Door
Printhead
Latch
Media
Supply
Window
Hinge
Plate
17