Xerox DocuColor 250 Online Help Manual page 291

P r od u c t Na me Bo o k N am e
• Clean Up: Automatically feeds stock from the tray following a
paper jam in the fuser so that the photoreceptor belt can be
cleaned before the job continues. To enable, mark the [Clean
Up] checkbox.
• Fuser: Allows the paper to be fed through the fuser or to
bypass the fuser. To enable, mark the [Fuser] checkbox.
• Tray Priority: Set a priority between 1 (highest priority)
through 99 (lowest priority) for the tray by entering a number or
using the spin-box.
Each tray is assigned a priority. The priority tells the system
the order in which the trays should be processed. All jobs in
the tray with the highest priority are processed before jobs in
trays with lower priorities. If a priority is not set, a default
priority is assigned to the tray when it is set up. If more than
one tray has the same priority, the tray are processed in
repeating succession.
• Choose the Tray Type:
– Fully Adjustable: Tray settings can be changed by all
users.
– Dedicated: Stock settings can be changed only by a
Trusted User or Administrator.
Coating FAB
The Coating FAB allows you to select options when coated stock
is used for jobs. From the Sides Coated pull-down menu select
from the following:
• Uncoated
• One Side
• Two Sides
If you select [One Side] or [Two Sides] the Coating Type pull-down
menu becomes active. Select from one of the available choices,
which are as follows:
• None
• Gloss
• High Gloss
• Semi Gloss
• Satin
• Matte
• Unspecified
Basic Settings FAB
The Basic Settings FAB enables the user to set the sides imaged,
and collation options.
-3