Xerox DocuColor 250 Online Help Manual page 65

P r od u c t Na me Bo o k N am e
• 1 Up More Information...
The 1 Up Layout Style centers the image on the output sheet.
It is differentiated from the None layout style in that you can
access and adjust advanced settings with this layout style.
• 2 Up More Information...
The 2 Up Layout Style places two images on a single page.
You can impose page 1 and 2 on one sheet of paper by
selecting the Sequential option under Pages on Sheet Side, or
you can impose two of the same images on one sheet of paper
by selecting the Repeated option. The output can be single-
sided or double-sided.
You may also select the Alternating option that imposes an
odd and even image on the front and the back (for example
image 1 on front and image 2 on back). The number of "ups"
chosen is determined by how many images are imposed. For
example, with 2 up chosen, image 1 is on the front with image
2 behind it, and image 3 is on the front with image 4 behind it.
• 2 Up - Flip Right More Information...
The 2 Up - Flip Right Imposition Model is used by customers
who wish to bind both ends of the output document and then
cut down the middle afterward. This model allows the 'cut
edge' to be the same on both finished booklets after binding
and cutting. The output can be single-sided or two-sided.
To illustrate how a 2 Up - Flip Right job is imposed, consider
an 8-page, 8.5"x11" job. You can output to ledger and create
two 8-page booklets that are identical, or you can output to
letter and create two 5.5"x8.5" booklets that are identical. If
duplex is selected, you would have original page 1 printed
twice on side 1 of the first sheet, with the second image 1
rotated 180 degrees relative to the first. Then, original page 2
would be printed in the same manner on side 2 of the first
sheet, and so on. Then, each end of the page could be bound
offline, and cut down the middle.
If you are printing images that go right to the edge along which
the cut takes place, you may need to adjust bleed and trim
settings in the Advanced Settings dialog.
• 2 Up - Cut & Stack More Information...
The 2 Up - Cut & Stack Imposition Model is used to create a
document which can be cut down the center and combined to
form one job. The output can be single-sided or two-sided.
To illustrate how a 2 Up - Cut & Stack job is imposed, consider
an 8-page, 8.5"x11" job. If the output is Ledger-sized paper
(11"x17"), you have 4 original pages printing on two Ledger
sheets. Page 1 is on the right-front of output sheet 1, and page
2 is directly behind it on the back of sheet 1. Page 3 is on the
right-front of output sheet 2, and page 4 is directly behind it on
the back of sheet 2. Page 5 is inverted (rotated 180 degrees)
on the left front of sheet 1, and page 6 is directly behind page
-47