Download  Print this page

Xerox DocuColor 250 Use Manual

Printing tabs using the docusp controller.
Hide thumbs
   

Advertisement

Dear Customer:
This document contains directions for printing tabs using the DocuSP controller with the DocuColor 250,
2045, 2060, 5252, 6060, 7000, 8000 printers.
At the printer:
1. Place tabs in appropriate Tray 3 (DocuColor 2045, 2060, 5252) or any tray (DocuColor 250,
6060, 8000).
Tabs are short edge feed.
Tabs face the back of the printer.
The last tab of the set must be on top if the job is programmed as N to 1.
Size: 9 X 11 inch.
Weight: program with the correct weight.
If the tabs are precut, be sure to program the tab sequence number, which is the number
of tabs in the set, not the number of tabs used. For example, if the tab set is 5 and only 3
tabs are being used, the tab sequence number is 5.
Example: Set up a job for seven tabs with the tab information included on the originals:
2. Place 8.5 x 11 inch paper in a paper tray short edge feed. Note, the only 8.5x11 stock
loaded must be short edge feed.
At the DocuSP, access the Printer Manager and follow these steps for setting tabs:
1. Select the "Stacking" tab.
701P44280
September 2005
1
Tab stock is typically purchased in sets of five tabs. For this job put aside the last
three tabs of bank two as they are not needed for this job.
Pre-collate the tabs in the tray for every set by reversing the order of the tabs.
For this job tab 7 is on top, tab 6 is after that, tab 5 is next, tab 4, tab 3, tab 2, tab
1.
Reverse Order would be for N to 1 job finishing, Otherwise 1 to N is Forward
Order.
Note: The tabs cannot just be pulled out of the box and flipped over because
they will be in the wrong sequence. Extra tabs can be saved for future jobs.
Tabs do not run at rated printer speed because they are heavier stock.
Use Manual job recovery if there is a jam. As jammed tabs are removed, replace
them in the paper tray in the proper order or the whole job will be thrown off.
Note: If the jammed tab is the furthest from the paper tray, it will have to be the
next tab fed by the printer.

Advertisement

   Related Manuals for Xerox DocuColor 250

   Summary of Contents for Xerox DocuColor 250

  • Page 1 This document contains directions for printing tabs using the DocuSP controller with the DocuColor 250, 2045, 2060, 5252, 6060, 7000, 8000 printers. At the printer: 1. Place tabs in appropriate Tray 3 (DocuColor 2045, 2060, 5252) or any tray (DocuColor 250, 6060, 8000). •...
  • Page 2 2. Select “Settings”. 3. Disable “Collated Stacking”. If this is left on, an error message displays and the job cannot be run. 4. Check the paper tray programming in the Printer Manager to make sure that the paper stock programming matches the stock in the printer paper trays. 5.

Comments to this Manuals

Symbols: 0
Latest comments: