Connecting The E10A-Usb Emulator To The Host Computer - Renesas HS7125EDB01H User Manual

2.3.3

Connecting the E10A-USB Emulator to the Host Computer

This section describes how to connect the E10A-USB emulator to the host computer. For the
position of each connector of the emulator, refer to the SuperH™ Family E10A-USB Emulator
User's Manual.
Notes: 1. When [Add New Hardware Wizard] is displayed, select the [Search for the best driver
for your device. (Recommended)] radio button and then the [Specify a location] check
box to select the path to be searched for drivers. The location must be specified as
<Drive>:\DRIVERS. (<Drive> is the CD drive letter.)
2. When a driver is installed in Windows
test may be displayed, but it is not a problem. Select [Continue Anyway] to proceed
with driver installation.
3. Be sure to install the software for the E10A-USB emulator before putting the emulator
in place.
Always switch OFF the emulator product and the user
system before connecting or disconnecting any CABLES
except for the USB interface cable. Failure to do so will result
in a FIRE HAZARD and will damage the user system and the
emulator product or will result in PERSONAL INJURY.
The USER PROGRAM will be LOST.
32
®
XP, a warning message on the Windows
WARNING
®
logo