Setup; Installing Emulator Software; Connecting The E2 Lite To The Host Machine - Renesas E2 Lite User Manual

E2 Lite

2. Setup

2.1

Installing Emulator Software

If you are using the E2 Lite, download and install the latest integrated development environment or flash
memory programming software from the following Web site.
https://www.renesas.com/e2lite_download
2.2

Connecting the E2 Lite to the Host Machine

Use the USB interface cable supplied with the product to connect the E2 Lite to the host machine as shown
in Figure 2.1.
For the position of each connector of the E2 Lite, refer to section 1.7, Names of the Emulator Parts.
Figure 2.1 System Configuration when Connecting the E2 Lite to the Host Machine
(1) Connect the A plug of the USB interface cable to the USB interface connector of the host machine.
(2) Connect the mini-B plug of the USB interface cable to the USB interface connector of the E2 Lite.
When you use the E2 Lite, be sure to use the USB interface cable supplied with the product.
The E2 Lite is turned on by connecting the USB interface cable.
Do not connect the E2 Lite to your host machine before having installed the integrated development
environment or Flash Programming software you will be using. The USB driver is automatically installed.
If the USB port of the host machine or the emulator to be connected is changed, the USB driver will be re-
installed.
R20UT3240EJ0300 Rev.3.00
May.15.20
Host machine
USB interface cable
E2 Lite
Setup
Page 19 of 36