Connecting The Host Machine; Turning On The Power; Checking Connections Of The Emulator System; Turning On/Off The Power - Renesas M34286T2-CPE User Manual

2. Setup
M34286T2-CPE User's Manual

2.7 Connecting the Host Machine

Connect the emulator and the host machine with the USB interface cable.
Connect the USB interface cable (included) to the USB interface connector (J2) and the USB port of the host machine
(see Figure 2.14).
Figure 2.14 Connecting the emulator system

2.8 Turning ON the Power

2.8.1 Checking Connections of the Emulator System

Before turning the power ON, check the connection of the interface cable to the host machine, emulator, and user
system.

2.8.2 Turning ON/OFF the Power

Turn ON/OFF the power of the emulator and user system as simultaneously as possible.
Do not leave either the emulator or user system powered on, because of leakage current the internal circuits may be
damaged.
When turning ON the power again after shutting OFF the power, wait for about 10 seconds.

2.8.3 Power Supply to the User System

This emulator cannot supply the power to the user system. Therefore design your system so that the user system is
powered separately.
The voltage of the user system should be 3.0 V ±5%. Do not change the voltage of the user system after turning on the
power.
CAUTION
Note on Switch Settings:
• Always shut OFF the emulator before changing switch settings and connecting the cable, etc. Otherwise
the internal circuit may cause a break.
R20UT0214EJ0200 Rev.2.00 Page 31 of 70
Sep 16, 2010