Selecting A Far-Site Camera; Controlling The Near-Site Camera - Polycom ViewStation EX User Manual

ViewStation EX User Guide

Selecting a Far-Site Camera

Controlling the Near-Site Camera

168
3. The system displays full screen the camera's current view on the
television monitor. A Camera icon appears in the upper right
corner pointing towards you.
To select a far-site camera source during a call:
1. Press the FAR button twice on the remote control. A series of
cameras pointing away from you (towards the far site) appears.
2. Press the left or right arrow key on the remote control to
highlight a video source. Then press the SELECT button on the
remote control.
-or-
After pressing the FAR button twice, press button 1, 2, 3, 4, or 5
to jump to a specific camera.
3. Press the SELECT button on the remote control.
The system displays full screen the far-site camera's current
4.
view on the television monitor. A Camera icon appears in the
upper right corner pointing away from you.
If there is no camera connected to the selected video source, you will
see either a blue screen or frozen video from the last video source.
Camera Control Mode—To control or adjust the camera on your
system, press the NEAR button on the remote control. A camera
icon appears in the upper right corner pointing towards you.
Tilt, Pan—Use the arrow buttons on the remote control to tilt the
camera up and down and to pan from side to side.
Zoom—Use the ZOOM buttons to zoom in and out.
Note
www.polycom.com