After Quick Setup - Bay Networks Nautica 200 Reference Manual

NauticaRS Release 4.1 Reference Guide
IPX Routing
Do you wish to run quick setup now?:
Enter the name of this router (e.g., accountname):
Enter the IP Address for this router.:
Are you using Cul-de-sac routing?:
3-20
After the Quick Setup option has run, and the configuration
changes are saved, it is important to be aware what has happened
to the router. Click on the option below to move to the next
section:

After Quick Setup

To set the router up for IPX routing, after entering setup the first
question you are asked is:
The default here is
is the only time you can cancel the setup procedure without
having to go all the way through to the end.
The next question is:
Enter here the name you wish your router to be known by or, if
you are connecting to the Internet via an Internet Service Provider
(ISP), enter the account name the ISP has given you.
Enter the IP address of your Nautica Router or the IP address
given you by the ISP. If you enter the address without a subnet
mask (i.e., 10.10.10.10/0 or 10.10.10.10) then the router will be
set up for Single Host Addressing. You must use Single Host
Addressing if you intend to use your Nautica unit to connect to an
ISP.
Cul-de-sac routing allows two networks with the same subnet
masks to communicate. For example, to save on limited IP
addresses, a remote office may use the same IP subnet as a central
office. The default option for this question is No, and to set up for
Standard routing, answer No to this question.
Click here if you wish to setup for
(for no); type
n y
Cul-de-sac
(for yes) to begin setup. This
Routing.
117237-C Rev. A