Bay Networks Nautica 200 Reference Manual page 224
Nortel nautica 200: reference guide
Hide thumbs
Also See for Nautica 200:
- Reference manual (642 pages) ,
- Release note (38 pages) ,
- Installation manual (23 pages)
Table of Contents
Advertisement
NauticaRS Release 4.1 Reference Guide
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
7-42
Mode
mode
sync
sync, async, framerelaysync
The operating mode of the device: Sync,
FrameRelaySync, or Async.
Use Sync for establishing connections to other Nautica
or PPP routers via a leased circuit connection. If
attaching to a frame relay network, either directly or via
a leased circuit, FrameRelaySync must be selected.
Async must be used if a V24 WIM module has been
installed and connected to an external modem.
Speed
sp
64000
A valid speed
The speed, in bits/second, of the interface.
Changing this parameter does not change the actual
device speed, which is determined by the attached DCE
clock rate. This parameter should be altered to allow the
correct device speed to be displayed in all the relevant
status screens.
Note:
to operate with the new settings, the device must be
powered off and on after changing the WAN device speed.
Also, if you are using the Manager port, the speed of the serial
port must be set at the speed of the WAN port.
117237-C Rev. A
Advertisement
Table of Contents
