Installing Remote Annex Software; Installing The Setup Program - Bay Networks NA Install Manual

Installing the Setup Program

Installing Remote Annex Software

T
his chapter describes use of the Setup program to install Remote
Annex Network Software for Windows. The installation example in this
chapter loads NA, Server Tools and Quick2Config Annex on a host
running either Windows NT Server 3.51 or Windows NT Server 4.0. The
chapter also covers installing NA and Quick2Config Annex on Windows
NT Workstations and Windows 95 systems.
If you are installing Remote Annex Network Software for Windows
from a Remote Annex Software for UNIX CD-ROM, the CD-ROM
does not include the Server Tools.
Before you install the Annex software, make sure the hardware and
software meet or exceed the minimum requirements described in
Chapter 1.
The Remote Annex Network Software for Windows is provided on a CD-
ROM along with an integrated setup program.
Before you install the Remote Annex Network Software, you should
close all other Windows programs.
Remote Annex Server Tools
Software Release 11.1 or a subsequent release. The CD ROM includes
the appropriate Remote Annex software release.
To install the Remote Annex software:
1. Insert the CD in your CD-ROM drive.
2. Use either Program Manager or File Manager to run:
[ CD-ROM Drive ]:\Disk1\setup
Setup opens a Welcome dialog box
Installing Remote Annex Network Software for Windows
Windows requires Remote Annex
for
(Figure 2-1).
Chapter 2
2-1