Bay Networks Nautica 200 Reference Manual page 172

NauticaRS Release 4.1 Reference Guide
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
5-12
DHCP-Enable
dh
No
No, Yes
The default option here is No; with the option set to Yes
the current router will be enabled as a DHCP server.
Setting this attribute to Yes allows the unit to pass
configuration information, such as permanent and
temporary IP addresses, to unconfigured units.
DHCP is explained in more detail in DHCP on
page 1-18 and its setup is outlined in Chapter 13.
BootP-Relay-Enable
bootp-relay-e
No
No, Yes
Enabling this option will forward BOOTP Relay
requests to the server specified in the
BootP-Relay-Server
If you want the Nautica router to forward BOOTP Relay
requests, then this option must be enabled. The BOOTP
server address must also be specified.
For more information on BOOTP Relay, refer to
page 1-21.
IP Address parameter.
117237-C Rev. A