Installing the Setup Program
Installing Remote Access Concentrator Software for Windows and Windows NT
T
his chapter describes use of the Setup program to install Remote
Access Concentrator Software for Windows. The installation example in
this chapter loads NA, Server Tools and Quick2Config Annex on a host
running either Windows NT Server 3.51 or Windows NT Server 4.0. The
chapter also covers installing NA and Quick2Config Annex on Windows
NT Workstations and Windows 95 systems.
If you are installing RAC Software for Windows from a Remote
Annex Software for UNIX CD-ROM, the CD-ROM does not include
the Server Tools.
Before installing the RAC software, make sure the hardware and software
meet or exceed the minimum requirements described in
The Remote Access Concentrator Software for Windows is provided on
a CD-ROM along with an integrated setup program.
Before you install the Remote Access Concentrator Software, you
should close all other Windows programs.
Remote Annex Server Tools
Concentrator Software Release 14.1 or a subsequent release. The CD
ROM includes the appropriate RAC software release.
To install the RAC software:
1.
Insert the CD in your CD-ROM drive.
2.
Use either Program Manager or File Manager to run:
[ CD-ROM Drive ]:\Disk1\setup
Setup opens a Welcome dialog box
Installing Remote Access
Concentrator Software
Windows requires Remote Access
for
(Figure
Chapter 2
Chapter
1.
2-1).
2-1