Editing A Remote Path - Bay Networks Nautica 200 Reference Manual

box# mod pa ppp/RemotePPP
path/ppp/RemotePPP#
117237-C Rev. A
Note:
In this example, the number of devices has been reduced.
You will have more devices and may need to page through the
options until you can see the paths. Follow the prompts on the
screen to move down through the lists.
The devices shown here represent the physical cards or ports in
the Nautica 4000. The
local network. The
to reach the ISDN number specified during the setup procedure
using PPP. The nau/RemoteNautica
to reach the ISDN number specified during the setup procedure if
have not consented to using PPP.

Editing a Remote Path

Remember, the RemotePPP and RemoteNautica paths may
change their names when the setup procedure places an automatic
call to them once setup is completed.
To edit a path, use the following syntax:
mod pa type/name
Where is the MTC for the verb MODify (page 17-20),
mod
the MTC that takes you into the path# context (Chapter 4),
the type of path to be edited (page 4-5) and
assigned to this path (page 4-7).
For example, to edit the RemotePPP Path, type:
The prompt will change to show that you are now in the path
object:
Once you are in the path object, typing
attributes. To change an attribute, use the following syntax:
Understanding the Command Line
path is the default path to your
eth/LAN01
ppp/RemotePPP
path is the path that is used
path is the path that is used
is the name
name
will list all the path
Info
is
pa
type is
3-25