Bay Networks Nautica 200 Reference Manual page 274

NauticaRS Release 4.1 Reference Guide
8-30
needs to be turned off as this path is for OSPF.
RIP-SUPPORT
OSPF-SUPPORT
must be set to Area 0 (the backbone) as this is the
OSPF-AREA
Area into which the path is connected.
Path B2
Path B2 travels from Router B into Area 2. It can have any
relevant Path Type (see page 4-5), but several attributes must be
set:
•
RIP-SUPPORT
•
OSPF-SUPPORT
•
OSPF-AREA
Note:
OSPF-AREA
Advanced-Manager
(page 5-15).
needs to be turned off as this path is for OSPF.
RIP-SUPPORT
OSPF-SUPPORT
must be set to Area 2 as this is the Area into which
OSPF-AREA
we are directly connected.
All the ABRs need to be set up in this fashion.
There are times when an ABR has no direct path into the
Backbone (Area 0). In
OSPF insists that all ABRs connect into Area 0.
If an Area, such as Area 3 in this example, has no direct link to
the backbone, OSPF allows a link to be made using Virtual Links.
needs to be set to OSPF2 to turn OSPF on.
none
ospf2
2
can only be changed if
has been set to
needs to be set to OSPF2 to turn OSPF on.
Figure 8-6, Area 3 is one such example.
Yes in system#
117237-C Rev. A